Pag. 5
PG029N
English
TECHNICAL DATA:
Adjustable iron thermostat set from 0°C to 215°C
Bimetallic safety iron thermostat with manual reset at 275°C
Heating element:800W - 230V
Boiler power : 2000W (2 x 1000W)
Working pressure: 3,5 bar
Max. pressure: 5,5 bar
Tank nominal capacity: 5,0 litres
TROUBLE SHOOTING:
PROBLEM
EXPLANATION
SOLUTION
Does steam go out
from the boiler?
It may happen that, while filling
the tank, some water spills over
the cap and flows inside the
boiler wetting the insulating
material
In order to solve the problem, we suggest using the
machine as usual so to dry up the insulating material
through the heat of the machine. In case you still
have this problem after one working hour, please
contact the service shop
Does the steam iron
leak steam mixed
with water?
While filling the tank you may
have poured too much water into
it.
The problem will go on until the excess water is
emptied. Keep the steam button depressed until the
water in the tank is at the correct level.
The iron plate has to be hot
before the steam passage
Please check that the temperature knob is on the
right position: “cotton
°°°)”
Does not the iron
give off steam?
The iron button might be off
Push the iron button the red le comes on; wait for 4
minutes so that the iron plate warms
The boiler button might be off
Push the boiler button the red led comes on: wait for
10 minutes so the boiler produces steam.
The water might be used up (the
low water light indicator might be
on)
Fill it to the required level following the instructions
carefully.
Does the ironing
board wet?
The ironing board cover might
not be able to absorb the steam
completely
You might use a thicker cover (or two covers) so to
create a thicker surface to absorb the steam better. In
case you are using a vacuum table, switch on the
vacuum function each time you are using the steam
The steam iron leaks steam
mixed with water (check by
spraying some steam on a dry
cloth)
See # 2
Does the iron leak
dirty water?
Maybe there is some dirty water
might have gone into the tank
and it is given off from the iron.
Fill the empty tank with 1 liter of water, screw the cap
up, shake it, open the cap and empty the tank.
Repeat the action until the water is cleaned. We do
not recommend the use of any additive to pour in the
tank. Before ironing again spray some steam on a
cloth until clean steam comes out.
The inserted data and pictures can be subject to changes without previous notice for the improvement of the
machine’s performances.
