25
Extended guide
9. The group head is just warm
a. Follow the instructions below:
1.Turn the machine OFF and ON and let some water come out from the group head.
2. Wait 24 min to check the steam manometer.
3. If the manometer shows 0, check the water level in the water tank and the correct
position of the water tank inside the machine.
4a. If the manometer shows a pressure increase, press the 3-position switch (9) to
select the position II. Let hot water come out from the group head (about 1 cup) and
wait 24 min until the machine reaches the right temperature to brew coffee.
4b. If the manometer shows no pressure increase, contact your reseller for check and
repair.
10. The machine does not heat, and the pressure does not increase
a. Follow the instructions below:
1. Check the power cord and make sure it is correctly inserted into the socket.
2. Check the water level in the water tank.
3. Check the correct position of the water tank.
4. Check the “water presence” pilot light (5): it has to be firmly ON.
5. Turn the machine OFF and ON.
6. If after 10 min the manometer registrates no pressure, contact your reseller for check
and repair.
11. The drip tray fills up too quickly
a. All the drainage tubes from the boiler end up into the drip tray, therefore check the
drip tray and empty it periodically.
12. After the backflushing the group lever (14) makes a strange noise and
is hard to handle
a. The backflushing procedure may remove the lubricants and the coffee oils. This
does not affect the machine functioning but may cause a strange noise of the lever
during handling.
b. The lever mechanism is lubricated by the oils released during the coffee extraction;
therefore, the lever will get lubricated again after 10/20 coffee extractions and the
strange noise will disappear.
c. For more details regarding the lubrication of the entire group mechanism and the
suitable product to use for this procedure, please contact your reseller.
