10
Door Reversal
4
4
8
8
3
3
7
7
2
2
9
9
1
1
6
6
5
5
8
8
3
3
9
9
2
2
4
4
7
7
1
1
6
6
5
5
This refrigerator has been built with the door hinges on the right. If you wish to change the
opening direction, follow the instructions below:
1. Remove the upper hinge cover ( 6 ) first.
2. Remove the two screws (1) that hold the upper hinge (5) (right side) to the frame. Take
away the upper hinge (5).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the two screws ( 8 ) that hold the lower hinge ( 2 ) and then remove the lower
hinge ( 2 ).
5. Remove the left front leg ( 4 ) and transfer it to the right side.
6. Move the hole cover plate ( 7 ) to the right side.
7.Before placing this lower hinge ( 2 ), remove the bolt-pin ( 9 ) and reverse the direction of the
lower hinge ( 2 ). Then install the lower hinge ( 2 ) onto the left side of the lower frame with two
screws ( 8 ).
8. Insert the bolt-pin( 9 ) into the lower hinge ( 2 ).
9. Set the door in place, making sure the door seat at the lower hinge( 2 ).
10. While holding the door in the closed position, attach the upper hinge ( 5 ) left side of the
top frame with two screws ( 1 ), do not tighten the two screws ( 1 ) until the top of the door is
parallel to the counter top.
11. Install the upper hinge cover ( 6 ) on the upper hinge.
