Before using the sander
Warning:
To avoid mistakes that could cause serious, permanent
injury, do not plug the sander in until the following steps are
completed.
1.
Assembly and alignment.
2.
Learn the use and function of no-volt switch. Backstop,
belt tracking knob, belt tension lever, work table and work
table tilt lock knob.
3.
Review and understand all safety instructions and
operating procedures in this manual.
4.
Review of the maintenance methods for this sander.
Before each use
INSPECT YOUR SANDER
Caution: Disconnect the sander
.
To avoid injury from accidental starting unplug the sander
before changing the setup, sanding disc or belt or adjusting
anything.
Check damaged parts.
Check for
alignment of moving parts
binding or moving parts
broken parts
work parts that cause a gap larger than 1/16” between
work support and sanding surface.
sanding belt narrower than 6 inches. Narrower belts
uncover parts that could trap your fingers.
worn or damaged electric cords
stable mounting, and
any other conditions that may affect the way the sander
works.
If any part is missing, bent, or broken in any way, or any
electrical parts don’t work properly, turn the sander off and
unplug the sander.
REPLACE
damaged, missing, or failed
parts before using the sander again
MAINTAIN TOOLS WITH CARE. Keep the sander clean for
best and safer performance. Follow instructions for
lubricating.
REMOVE ADJUSTING KEYS AND WRENCHES from tool
before turning it on.
Warning:
To avoid injury from jams, slips or thrown pieces:
USE ONLY RECOMMENDED ACCESSORIES. Consult
this owner’s manual for recommended accessories. Follow
the instructions that come with the accessories. The use of
improper accessories may cause risk of injury to person.
Adjust any work support to clear the sanding surface by no
more than 1/16”. When checking clearance between the
belt and work support, press the belt that against the metal
beneath it.
Make sure all clamps and locks are tight and no p[arts have
excessive play.
Keep work area clean. Cluttered areas and benches invite
accident. Floor must not be slippery.
To avoid burns or other fire damage, never use the sander
near flammable liquids, vapors or gases.
PLAN AHEAD TO PROTECT YOUR EYES, HANDS, FACE,
EARS.
KNOW YOUR SANDER.
Read and understand the owner’s
manual and labels affixed to the tool. Lean its application and
limitations as well as the specific potential hazards peculiar to
the tool.
To avoid injury from accidental contact with moving parts:
KEEP GUARDS IN PLACE and in working order.
Don’t do layout, assembly, or setup work on the sander while
any parts are moving.
BASIC OPERATION
11
EN
Summary of Contents for BDS610
