16
- Carefully remove the dust bag (16) from the inlet fitting.
- Place a new dust bag into the tank and press the dust bag connection firmly on to the inlet fitting.
- Put back the motor body (3) on the containing trunk (13), and lock the motor body with both closing hooks (4).
Installing/changing the sponge filter (Optional accessory) (Fig 4)
- Unlock the closing hooks (4) and take off the motor body (3).
- Make sure that the tank is clean and perfectly dry.
- Carefully remove the dust bag (16) from the inlet fitting.
- Carefully remove the cartridge filter (15) from the filter rack.
- Insert correctly the sponge filter (20), perfectly dry and clean, onto the filter rack, and adjustit onto the rack until it
is completely covered.
- Put back the motor body (3) on the containing trunk (13), and lock the motor body with both closing hooks (4).
OPERATION
Switching On and Off
- Insert the plug into a suitable wall outlet.
- Press the switch (10) and put it on “I” position for starting the appliance.
- For stopping the appliance, press again the switch (10) and put it on “0” position.
Sucking dust (dry)
- Make sure that the paper bag (16) is installed properly in the trunk.
- DO NOT suck water or other liquids with the paper bag (16) mounted.
- The cartridge filter (15) must be cleaned after each use.
CAUTION!
Do not pick up flammable substances.
Sucking water or other liquids
- Make sure that the cartridge filter (15) or the sponge filter (20) is installed properly in the trunk.
- DO NOT suck water or other liquids without filter mounted on the filter rack.
- Check the floating valve (21) operating before picking up liquids (Fig 5).
- During sucking water, the sucking may be interrupted and the appliance will make an abnormal noise.
Immediately switch the appliance off, remove the plug from the socket, unlock and remove the motor body (3) from
the trunk, then empty the content of the trunk.
- If foam appears, stop the appliance immediately and empty the tank.
CAUTION!
Do not pick up flammable substances.
Outlet socket
To connect your power tool to the vacuum cleaner:
- Make sure that the power tool is switched off.
- Connect the power tool to the appliance socket (11).
- Press the switch (10) and put it on “II” position.
- The vacuum cleaner motor starts when the connected power tool is switched on.
- When the power tool is switched off, the vacuum cleaner continues to run for 5-8s so that any dust in the suction
hose is conveyed to the filter bag.
CAUTION!
The maximum power consumption of the connected power tool is 1800W maximum.
Filter cleaning system “Push & Clean” (Fig 6)
When feeling the suction is weak and suction performance drops during usage, the cartridge filter can be cleaned
during operation, ensuring the continued high suction.
- Jam the handle (7) with the palm of your hand.
- Press the filter cleaning button (2) 10 to 15 times.
