LeMond Fitness G-Force RT, Assembly & Instruction Manual

ASSEMBLY AND INSTALLATION INSTRUCTIONS

3..3  Rear Stabilizer

1.  Locate the rear stabilizer and the 

leveling feet.

2.  Slide the rear stabilizer into place at the 

rear of the body frame from the right 

side and rotate until the set screw is 

positioned in the alignment notch.  As 

with the front stabilizer, be careful not to 

dislocate the plastic sleeve.

3.  Align the holes for the attachment 

screws on the body and the rear stabi-

lizer.  Secure the rear stabilizer by sliding 

star washers onto each of (2) M8x30 screws and tighten with the 6mm hex wrench.

4.  Attach the leveling foot to the rear stabilizer by screwing it into the underside of the rear 

stabilizer.  Assume at first, that your floors are level and install each foot snugly against the rear 

stabilizer.

3.. Display Console

Attaching the Console Mast to the Bike

1.  Before installing the console mast to the body, 

locate the (2) wires at the top of the front tube 

on the body.  Feed the wires through the tub-

ing and out of the hole at the top of the console 

mast.

2.  Insert the console mast into the front tubing of 

the body, taking care to align the holes for the at-

tachment screws of the mast with both the body 

and the plastic sleeve.

3.  Secure the console mast to the body by sliding 

star washers onto each of (3) M8x20 screws and 

tighten with the 6mm hex wrench.