- 5 -
Dimmer Control
The display DIMMER selector switch located on the right side cabinet was set to the HIGH position at our
factory.
If you find the display to be too bright for sleeping, slide the DIMMER selector switch to the LOW position.
Sleep To Music Timer
You can use the sleep timer to fall asleep to the Radio, CD player or USB/SD/MMC music up to 90 minutes
and have the unit shut off automatically.
1) Press the ALARM OFF/POWER button to turn the power On . Operate the Radio, USB/SD/MMC
music or CD player as usual. Adjust the VOLUME to the desired level.
WARNING: The level you select for Sleep To Music is the same level you will hear when the alarm turns
On in the morning.
2) Press the SLEEP button to select the desired amount of sleep timer from 90 minutes to one minute. The
SLEEP indicator comes On .
3) When the display shows the desired amount of time, stop pressing the SLEEP button. After 5 seconds the
display changes back to the correct time. The Radio, CD player or USB/SD/MMC music will continue
until the sleep timer counts down to 00
and then shut off automatically.
4) To stop the Radio or CD player before the sleep timer counts down to 00 , press the ALARM
OFF/POWER button to turn the unit Off .
Note: If you are falling asleep to CD or USB/SD/MMC, the sound stops when the disc ends, even if a longer
sleep time was selected.
Listening To The Radio
1) Press the ALARM OFF/POWER button to turn the unit On . The POWER LED indicator comes on.
2) Press the FUNCTION button until the FUNCTION indicator turns off to select the Radio function.
3) Rotate the TUNING control on the right side panel to tune to the desired station. Press the ST/MONO
button if the received program is too noisy.
4) Rotate the VOLUME control on the left side panel to adjust the volume level.
5) When you are finished listening press the ALARM OFF/POWER button to turn the unit Off . The
POWER LED indicator goes off.
FM Antenna Wire
Make sure the FM lead wire antenna is extended to it s full length. You may have to vary the direction of the
wire antenna to find the position that provides the best reception.
Playing CD/MP3 Discs
NOTE: Although this CD/MP3 player can read CD-R and CD-RW discs, in addition to normal CD/MP3,
however the playability of CD-R/RW discs may be affected by the type of software that was used to create
the discs, as well as the quality and condition of the blank media you are using. 100% playability cannot be
guaranteed. This is not an indication of a problem with the player.
Normal Playback
1) Press the ALARM OFF/POWER button to switch the unit On . The POWER LED indicator comes
On .
2) Press the FUNCTION button until the FUNCTION indicator turns on red to enter CD playing mode.
shown on display.
3) Press on the CD door in the area marked OPEN/CLOSE to open the door. If you have not already done so,
remove the dummy CD transit protection card from the CD player and discard it.
4) Place your disc on the center spindle with the printed label side facing up. Press down near the center of
the disc to make sure it is firmly seated on the spindle, press OPEN/CLOSE area to close the CD door.
5) The display will show
flashing, then the total number of tracks will appear on the display for a
few seconds and start playback from the first track. The display returns to the correct time after several
seconds. To see the track number at any time during playback press the DISPLAY button.
Note: If the disc is inserted incorrectly, or if the disc is badly scratched and cannot be read by the player,
- - - - will appear on the display for a few seconds, and then the display returns to the correct time.
