20
8.
PROBLEMS AND POSSIBLE SOLUTIONS
Headset doesn’t work / no sound:
•
The base isn’t switched on. Check whether the adaptor is connected
and inserted into the wall socket.
•
The headset isn’t switched on or the battery is empty. Switch on the
headset by sliding the switch to ON. If the LED still doesn’t
illuminate, then the battery is exhausted. Please charge it
immediately.
•
When the headset was set to ON when you took the headset from the
base, you must first slide the switch to OFF and then back to ON to
enable the headset.
•
The source that must provide the audio (TV, radio) isn’t switched on or
its volume is set to zero. Switch on the audio source or increase the
volume somewhat.
•
The volume of the headset is set to zero. Use the volume control of
the headset to increase the volume.
•
You’re out of range from the base. Decrease the distance.
•
The headset is paired with the phone and not with the TV or radio. If
necessary, refer to the end of paragraph 6.2 for how to re-register the
headset on the base.
The switch of the headset is set to ON, but the Status LED is not
illuminated:
•
The headset was just taken from the base. Briefly slide the switch of
the headset to OFF and back to ON to enable the headset again.
Only one side can be heard:
•
The balance control of the headset is turned fully to one side. Turn
this control to the center position to set both ear speakers to the
same volume.
