KEY CONTROLS AND FUNCTIONS
MAIN UNIT
1) Cassette buttons cover
2) Cassette buttons
3) LCD display
4) Volume knob
5) Function button
6) Alarm button
7) Snooze button
8) Display/ID3 button
9) Play Mode button
10) On/Standby button
11) Preset EQ button
12) USB Socket
13) 3.5mm Headphone jack
14) Standby LED indicator
15) Remote sensor
16) Memory/Clock-Adjust button
17) Stop
/
St-Mono button
18) Play/Pause
button
19) Skip/Tuning Up
/
Down
button
20) CD Tray Open/Close button
21) Folder/Pre-Up button
22) CD tray
23) SD/MMC card slot
24) Aux-in socket
25) Fm wire antenna
26) AC cord
27) Speaker outlet (L/R)
Caution:
Usage of controls, adjustments or performance of procedures other than those specified in this manual may result in hazardous
radiation exposure.
This unit should not be adjusted or repaired by anyone except qualified service personnel.
Important:
Since movement of the CD mechanism and the sensitive circuitry may cause interference to the radio tuner nearby, switch this
unit off while operating other
radio devices
Precautions for use
Installation
•
Unpack all parts and remove protective material.
•
Do not connect the unit to the mains before checking the main voltage and before all other connections have been made.
•
Do not cover any ventilation openings and make sure that there is a space of several centimeters around the unit for
ventilation.
Connection
1. Connect the AC cord (26) to the AC outlet, the unit will turn to standby mode and the Standby LED indicator (14) will light up.
2. Connect the speaker wire to the Speaker Terminal (27) located on the back of unit.
3. Turn on the unit (10). If the backlight of the LCD display (3) is on, it means that the power supply is ok. Now your system is
ready to operate.
Setting the clock
1. Set the unit in standby mode.
2. Press & hold the “ Mem/Clk-Adj ” button (16). First you can choose between 12 hour (AM/PM) or 24 hour clock presentation.
Press Skip Up
or
Skip Down
button (19) to set 12/24 hour. Press “ Mem/Clk-Adj ” button (16) to store the correct
hour.
3. Now the hour digit(s) of “ 0:00 ” are flashing on the LCD display (3). Press Skip Up
or
Skip Down
button (19) to
set the correct hour. Press “ Mem/Clk-Adj ” button (16) to store the correct hour.
4. Now the minutes digits are flashing, press the Skip Up
or
Skip Down
button (19) to set the correct minutes. Then
press “ Mem/Clk-Adj ” button (16) to store the correct minute.
