FM OPERATION
Switch to the FM mode.
SCANNING FOR STATIONS
1. You can scan up or down the frequency range manually by pressing
the buttons on the remote or pressing buttons on the
unit to increase or decrease the frequency in
0 .05 MHz
increments.
To scan through the frequency range quickly press and hold the
buttons on the unit or press the buttons on the remote control.
2. Once a station has been found, the scanning will stop automatically.
If no station is found, then the tuning will stop once it has cycled
through the entire FM band
(87.5-108MHz)
.
SCAN MODES
When performing an scan, you can set the sensitivity level of the
stations to be found. E.g. : Strong stations only or All stations.
1. In FM mode, press the
STOP/MENU
button, when
<Scan setting>
appears on the display press the
ENTER
or
PLAY/PAUSE
button to
view the submenu.
2. Use either on the unit, on the remote to select either
<All stations>
(which will detect any stations, even with a weak
signal) or
<Strong stations only>
(which will only detect stations
with a good signal strength). Press the
ENTER
or
PLAY/PAUSE
button to select the required option.
3. When you perform a scan as described above, only stations fitting
the applied setting will be detected.
STORING STATION PRESETS
It is possible to store up to
10
of your favorite stations.
This will enable you to access your favorite stations quickly and easily.
1. To store a preset, you must first be listening to the station that you
would like to save.
2. Then press and hold one of the numeric buttons from
1-0
to store
the station under that number. You will see
Preset X Stored
appear
on the display with
X
being the number you stored the station under.
/
13
/
/
/
/
/