UK-3
3.
After the alarm wake-up time is set, you will continue to go for the alarm wake-up mode settings -
repeatedly press the or
button for the selections followed by pressing the
ALARM
button to
confirm, first set the alarm wake-up volume level (01-32), then the wake-up radio station (P01-P10),
and finally the buzzer tone (HI/LO). (F. 6) (F. 7) (F. 8)
4.
After the confirmation of the buzzer tone selection, the alarm set up is completed.
5. To check the alarm settings, press the
ALARM
button once, the alarm wake-up time and the wake-up
mode settings will be displayed one by one in two seconds intervals.
Activating the alarm and the wake-up mode
1. Repeatedly press on the
ALARM
button to activate the alarm function and select the wake-up mode,
the alarm icon and the corresponding wake-up mode will appear in the display on every press:
“Tuner > USB > Buzzer > OFF > Tuner > USB > … …”.
2. When your desired wake-up mode appears in the display, release the buttons, the alarm function is
now activated and the alarm icon will be displayed. (F. 9)
3. At the selected wake-up time, the selected wake-up mode will be on and the alarm icon in the display
will flash to indicate the alarm is triggered. It will continue for one hour and then shut off
automatically. To stop the alarm sooner, press the button once.
Note:
If alarm wake-up to USB is selected and no USB is being inserted or recognized, when the alarm
arrives, the buzzer sound will be activated in place automatically.
Automatic alarm repeat
The alarm will automatically repeat each day at the selected wake-up time as long as the alarm icon is
displayed (alarm function on). To cancel the alarm, repeatedly press the
ALARM
button until the display
shows “OFF”, and the alarm icon will be disappeared.
Snooze function
During alarm, press the
SNOOZE
button will temporary switch off the alarm for 5 minutes and the snooze
icon will be displayed. This is repeatable in the one hour alarm duration. (F. 10)
LISTENING TO THE RADIO
When the unit is powered up and switched on for the first time, it will automatically enter into the FM radio
mode. To select radio mode during other operation modes, repeatedly press the
MODE
button on the front
panel until “TUNER” and the FM frequency are displayed. (F. 11)
Manual tuning
1. To select jog dial manual tuning, first press on the
VOLUME/SCROLL
control once, then rotate the
same control until you read the correct frequency or the reception is at its best.
2. The display will show the stereo icon if a FM stereo station is received. To select FM mono reception,
press the ►
/II
button, and the stereo icon will disappear in the display. (F.12)
Automatic tuning
1. Press and hold the
VOLUME/SCROLL
control for longer than two seconds to scan up or down the
frequency band, it will automatically search for the first station of sufficient signal strength.
2. Repeat the above procedure if you wish to search for another station.
F.4
F.6
F.7
F.5
F.8
F.9
F.10
◀◀
II
▶▶
II
