© 2020 Carrier. All Rights Reserved. LenelS2 is a part of Carrier.
3
DOC-6005-EN-US — revision 1.002
Specifications
Signaling Outputs
Connections
Compliance
This power supply unit meets the essential requirements of the following
European Directives:
•
Low Voltage 2014/35/EU
•
EMC 2014/30/EU
•
WEEE 2012/19/EU
•
RoHs2 2011/65/EU
Product Warnings and Disclaimers
THESE PRODUCTS ARE INTENDED FOR SALE TO, AND
INSTALLATION BY, AN EXPERIENCED SECURITY
PROFESSIONAL. LENELS2 CANNOT PROVIDE ANY ASSURANCE
THAT ANY PERSON OR ENTITY BUYING ITS PRODUCTS,
INCLUDING ANY “AUTHORIZED DEALER”, IS PROPERLY
TRAINED OR EXPERIENCED TO CORRECTLY INSTALL SECURITY
RELATED PRODUCTS.
For more information on warranty disclaimers and product safety
information, please check
https://firesecurityproducts.com/en/policy/
product-warning
or scan the following code:
Input Specifications
Voltage (rated)
100 - 240 VAC
Voltage (operating)
90 - 264 VAC
Frequency
50 - 60 Hz
Maximum Current
2 A @ 90 VAC
Mains Input Fuse
T3.15A (20 mm 250 VAC)
Output Specifications
Voltage
13.5 - 14.2 VDC (13.8 VDC nominal) on
mains power; 10.0 - 12.3 VDC on battery
standby
Maximum Load
Current
4 A (max)
Ripple
150 mV pk-pk max
Load Output Fuse
F4.0A
Overload
Electronic shutdown until overload or short
circuit removed (under mains power only)
Standby Battery
Battery Type
12 V Valve Regulated Lead Acid
Battery Capacity
1 x BS131N 18Ah max
Battery Charging
Fuse protection
F4.0A
Mechanical
Enclosure Dimensions
400W x 500H x 80D (mm)
Weight (excluding battery)
5.8 Kg
Enclosure Material
Steel - white powder coated RAL 9003
IP and IK Ratings
IP30/IK08
Environmental
Temperature
-10 to +40° C (operating) 95% RH
non-condensing; -20 to +80° C (storage)
GEN Fault
(general)
0.1A @ 60 VDC N/O volt-free contact. Open when
battery is disconnected, *output fuse fail, battery
fuse fail or output short circuit. (*Applies only to O/
P 1 of multiple fused units)
EPS Fault
(mains)
0.1A @ 60 VDC N/O volt free contact; open when
loss of mains for more than 10 s
Lid Tamper
3A @ 125 VAC N/O volt free contact.
Note:
Contact open in when lid opened by
normal means or unit is removed from
mounted surface (TAMPER ACTIVE
condition).
+LOAD 1,2,3,4
+ve voltage output to load equipment
-LOAD 1,2,3,4
-ve voltage output to load equipment
EPS Fault
Volt-free contacts for loss of mains indication
GEN Fault
Volt-free contacts for general faults
(see
+BATT
+ve (red lead) connection to standby battery
-BATT
-ve (black lead) connection to standby battery
