Introduction
Thanks for purchasing our Classic FET Compressor, this is our version of the well
known FET compression designs, including all the character and fast response you
could expect from it, as well as some added features like True bypass or Sidechain
HPF which are extremely useful in the modern studio environment.
Built in a 19” 2U. Rack chassis, uses high quality VU-Meter for Gain Reduction or
Output Level monitoring. using RGB LED illumination, the meter also displays useful
information like overcompression or bypass state. Additionally, Bypass is Wi-Fi
controllable, allowing you to make precise A/B comparison from the listening spot.
Below you can find the block diagram for the audio path.
Installing your compressor
Before plugging the unit to mains power, check the rear voltage switch position is set
for your local voltage (110VAC 60Hz. or 220VAC 50Hz.)
The audio input and output uses XLR connectors to receive and send balanced
signals. Although we highly advise using balanced cables, the unit will work with
unbalanced input and will feed unbalanced devices through it’s output, just keep in
mind the 6db’s loss when using unbalanced cables.
Although all our products are built, tested and packed conscientiously, some
problems may occur during transport. If you find any problem or malfunction please
unplug the unit and contact us to
to find a solution or
replace the unit.
2
Classic FET Compressor - User Manual