Introduction
Thanks for purchasing our LocFi. We hope you enjoy using it as much as we enjoyed
designing and building it.
LocFi is a ‘dynamic distortion unit’ based on the Shure Level-Loc PA Limiter from the 60’s.
Featuring a unique character, this JFET based limiter provides the same aggressive
compression from the original, with added functions which allow you to shape the effect
from subtle texture to highly distorted and pumping sound.
Now in Stereo Rack format, the device is built in a 1u. Rack, using XLR Input & Output
connectors and Low-Noise internal PSU.
It’s designed to provide characteristic sound, while being able to get different results and
not being a ‘one trick horse’. It works great on drum room tracks, but it’s not limited to them,
i.e. some of the prototypes users reported successful application on voice tracks, applying
a small amount of the processed signal just to give a gritness layer and a bit of colour. With
a unit like this, experimentation is the key.
Installing the unit
Before plugging the unit to mains power, check the rear voltage switch position is set for
your local voltage (110VAC 60Hz. or 220VAC 50Hz.)
The audio input and output uses XLR connectors to receive and send balanced signals.
Although we highly advise using balanced cables, the unit will work with unbalanced input
and will feed unbalanced devices through it’s output, just keep in mind the 6db’s loss when
using unbalanced cables.
Although all our products are built, tested and packed conscientiously, some problems may
occur during transport. If you find any problem or malfunction please unplug the unit and
contact us to victornafria@lennardaudio.com to find a solution or replace the unit.
2
LocFi Stereo - User Manual
