Page 2
507518-02
The remote indoor sensor when connected and configured
will act as a room temperature sensor instead of internal
temperature sensor available with the thermostat. The dip
switch is used to select either built-in or external remote
indoor temperature sensor used for temperature control.
Table of Contents
5/2 Day Programmable Thermostat
1
. . . . . . . . . . . . . .
General
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Initial Thermostat Power‐up
2
. . . . . . . . . . . . . . . . . . . . .
Buttons, Backlight, Timers & Settings
3
. . . . . . . . . . . .
DAY/TIME - Set Day and Time
4
. . . . . . . . . . . . . . . . . .
HEAT - Heat Mode
4
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
COOL - Cool Mode
5
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
HOLD - Temperature Hold Mode
6
. . . . . . . . . . . . . . . .
PROG - Thermostat Programming
7
. . . . . . . . . . . . . . .
FAN - Controlling Fan Operation
9
. . . . . . . . . . . . . . . . .
SETTINGS - Filter and Maintenance Reminders
10
. . .
SETTINGS - Balance Point
11
. . . . . . . . . . . . . . . . . . . . .
Service Indicator
12
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Thermostat RESET
12
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Removing/Installing Thermostat
13
. . . . . . . . . . . . . . . . .
Default Thermostat Settings
13
. . . . . . . . . . . . . . . . . . . .
Technical Specifications
13
. . . . . . . . . . . . . . . . . . . . . . . .
General
These instructions are intended as a general guide and do
not supersede local codes in any way. Consult authorities
having jurisdiction before installation. Check equipment for
shipping damage. If you find any damage, immediately
contact the last carrier.
Initial Thermostat Power‐up
When power is initially applied to the thermostat, the display
will appear as shown in figure 1.
FAN
ON
AUTO
SYSTEM
COOL
OFF
HEAT
12:88
88
AM
PM
ROOM
88
MO TU WE TH FR SA SU
SETPOINT
°
°
SERVICE
FILTER
MAINT
Hi
Lo
PROG
A | B | C | D
HOLD
Figure 1. Initial Power-Up Display
NOTE - Tables 3 on page 13 lists all of the system defaults.
