background image

E

2017 Lennox Industries Inc.

Dallas, Texas, USA

THIS MANUAL MUST BE LEFT WITH THE HOMEOWNER

FOR FUTURE REFERENCE

INSTALLATION
INSTRUCTIONS

ComfortSense

®

 3000 Series

Models L3011C

/

L3021H

Non‐Programmable
Thermostats

CONTROLS

506080-02 
5/2017
Supersedes 506080-01

Table of Contents

L3011C /L3021HThermostats

1

. . . . . . . . . . . . . . . . . . .

General

1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Shipping & Packing

1

. . . . . . . . . . . . . . . . . . . . . . . . . . . .

Requirements

2

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Installation

2

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Thermostat Operation

3

. . . . . . . . . . . . . . . . . . . . . . . . . .

DIP Switch Settings

3

. . . . . . . . . . . . . . . . . . . . . . . . . . .

Wiring Diagrams

5

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

WARNING

This product contains a chemical known to the State of
California to cause cancer, birth defects, or other
reproductive harm.

WARNING

Improper installation, adjustment, alteration, service or
maintenance can cause personal injury, loss of life, or
damage to property.

Installation and service must be performed by a licensed
professional installer (or equivalent) or a service agency.

L3011C/L3021H Thermostats

These are non‐programmable electronic thermostats
which are easy‐to‐use, have a large, easy‐to‐read display,
and provide excellent temperature control. Both thermo­
stat models also includes a programmable filter change re­
minder, and a system check indicator which will notify the
user of the need for equipment service.

Thermostat model L3011C is suitable for non‐heat pump,
single-stage heat/single-stage cool applications that are
matched with a gas or electric furnace.
Thermostat model L3021H is suitable for single-stage heat
pump applications that are matched with a gas or electric
furnace as the auxiliary heat source. An optional outdoor
temperature sensor provides auxiliary heat lockout/bal­
ance point operation and dual-fuel compatibility.

General

These instructions are intended as a general guide and do
not supersede local codes in any way. Consult authorities
having jurisdiction before installation.
Check equipment for shipping damage. If you find any
damage, immediately contact the last carrier.

Shipping and Packing List

1 - Thermostat (L3011C or L3021H)
2 - Plastic wall anchors
2 - Screws

Optional Accessories

 Outdoor Sensor (used with L3021H only): X2658
 Wall Plate: X2659

Summary of Contents for ComfortSense L3021H







Reviews: