icomfort
Wi‐Fi
®
7-Day Programmable Communicating Thermostat
Page 3
Start Up
In event of power failure
—If a power failure occurs,
when the power comes back on, the thermostat will reboot
and when complete, the HOME screen will return.
WHAT THE HOME SCREEN TELLS YOU...
After the thermostat and the
system has been fully connected
and powered on, the icomfort
Wi‐Fi
®
thermostat's Home screen is
displayed. Figure 1 shows a
display and describes what the
thermostat is telling you.
Note that set to
heat or cool
communicates that the system
is operating in
manual
mode;
if it were in
program
mode,
the heat or cool button would
read
summer program is on
(or other named program).
OTHER INFORMATION...
Until and unless the indoor temperature
is at or between the two settings
(70 to 75 degrees in this example), the system
should run until it does measure within that
temperature range.
“Wi-Fi” in the bottom lift corner is the “button” to access
the Wi-Fi settings screen. Wi-Fi with a
beneath it indicates
a prior connection to the server has been lost. If a connection had
been lost, then re-established, the triangle goes away.
Away Mode
sets the thermostat for energy saving while you are gone for an
extended period of time. In this mode, the system will only come on if indoor
temperature falls below 62 degrees (for heating) or if indoor temperature rises
above 85 degrees (for cooling).
WHAT YOU CAN DO FROM THE HOME SCREEN...
Typically, what every homeowner wants from an air
conditioning system is to be able to control that
system using a convenient device to
adjust heating, cooling, and the
level of humidity in the home.
From this screen you may:
- adjust temperature
settings
- access menus to change the
program mode
- change how the
fan operates
- access the “Features screen”
(fig. 3) by pressing
- access and view active ser
vice alerts by pressing the
icon
- access help screen by press
ing the
“?”
icon.
Adjusting the temperature and changing the
system mode of operation is described fully
beginning on Page 14.
Adjusting the humidity, even if no physical humidifier or
dehumidifier is present, may also be available, provided the
installer has implemented the feature during setup.
See Page 17 for details on humidity control.
indoor temperature
indoor humidity is 41%
cool-to
set temp
75
heat to
70
heat
or
cool
outdoor
temperature
80
press to go
to Features
use arrows
to change
temperature
indoor
temperature
indoor
humidity
outdoor
temperature
cool-to setting
heat-to setting
system
mode
system
status
fan is set
to AUTO
service
alerts are
present
time, month, day, year
(press to change)
(if either feature below
is turned on)
(if feature is
turned on)
Figure 1. Home Screen (Typical)
Wi-Fi setup
button
system is cooling
9:39 am January 23, 2012
Wi-Fi
?
enter
away
Zone 1
Zoning (if
installed and
enabled)
help screen
Away Mode
fan is
OFF
fan is
AUTO
forecast
Hi 85
Lo 60
Internet
weather
forecast
