iComfort
Wi‐Fi
®
7-Day Programmable Communicating Thermostat
47
Using the Secure Web Portal
Access all the great Wi-Fi enabled features on your iComfort
®
thermostat
from our secure web portal.
www.myicomfort.com
After signing in, you’ll be able to view your iComfort system settings, adjust
the temperature and view reminders and alerts – just as you would on your
iComfort thermostat at home. With a familiar look and settings this simple,
you should feel right at home. Don’t forget to check out the available Apps
and skins.
From the web portal welcome page, you may also click on links to launch an
interactive demo or learn more about iComfort.
Screen-Saver
You can also customize the screen-saver by uploading your own photo on·
www.myicomfort.com
under the tab ”skins”.
Image must be 800x480 DPI
in JPG format.
HOW DO I TURN ON SCREEN-SAVER
1.
From the thermostat
Home
screen, press
.
2.
Press the
display setting
button.
3.
Press the
screen saver
button.
4.
From the pop-up menu, select either
on
for the default screen-saver
or
skins
for your custom uploaded image. The skin picture will appear
after 30 seconds of inactivity.
When set to
off
, the screen stays on.
When set to
on
, after 30 seconds of inactivity the screen will go
blank
When set to
skins
and no skin or custom image has been
uploaded, the screen will display LENNOX after 30 seconds of
inactivity. If a skin or custom image has been uploaded, after 30
seconds of inactivity, the image will be displayed.
Accessing Installer Screens and Changing Equipment
Parameters
To access the installer screens after the unit has been placed in operation
and the user home screen is displayed, touch the “Lennox” logo and hold for
5 seconds. The system will access the installer screens.
A message screen stating “Qualified Lennox equipment installer warning”
screen appears.
When pressing
yes
, the thermostat will search for communicating
devices in the system.
When pressing
no
, the thermostat returns to the main screen.
When pressing
reset
, the thermostat resets all parameters to factory
default, searches for communicating equipment and erases all
information concerning non-communicating equipment previously
stored in the thermostat.
After initial installation, if an alert is present when you are making changes to
settings, no action on the alert is mandatory.
Press
equipment
if you need to set up equipment parameters and edit
details of devices in the system.
Press
diagnostics
if you need to analyze the system (see page 18).
If any component of the HVAC system has been changed, e.g. replacing an
outdoor sensor, reconfiguring the system will be required. To begin
reconfiguring a system (after you have accessed the program from the
Lennox logo [previous page]), touch the
setup
button. The “Start system
configuration” screen will appear. Press
start
to proceed. The “Re-configure
confirmation” screen will appear. This reminder notes that
system
configuration
may affect some existing device settings and prompts to
confirm
or
cancel
the configuration process.
Press
confirm
to continue system configuration; the screen will change to
the system discovery screen. At this point, the program goes through the
same setup as the initial setup process which begins on page 3.
NOTE - “Compatible device found” screen (shown below) appears only
when a device has been removed and replaced with a compatible device.
