17
13. Local Display Components and Installation
13.1. Installation
a.
Hold the Local Display by the edges, line it up with the Mag-Mount, and
move the Local Display toward the Mag-Mount.
b.
When the magnets in the Mag-Mount attract the Local Display, guide it
toward the Mag-Mount and let the magnets pull it into place.
c.
Lightly press on the sides of the Local Display to verify it is completely
seated on the Mag-Mount.
d.
To remove the Local Display from the Mag-Mount, rotate the Local Display
right or left (clockwise or counter-clockwise) at least 30 degrees to disengage
the plastic hooks and then pull it straight off of the Mag-Mount
WARNING
Failure to rotate the Local Display before pulling it off of the Mag-Mount may
loosen the dry wall anchors or pull the Mag-Mount off of the wall due to the
increased forced required to separate the Local Display from the Mag-Mount
when it is not rotated.
NOTE:
If the Local Display is removed from the Mag-Mount base, the display
will shut down and will not be able to communicate with the system.
System can be controlled from the web portal once registration has
been completed.
e.
Do not remove the label covering the Local Display screen until after power
is applied to the system.
CAUTION
1) Battery may need to charge before operation. Once the display
is connected, instructions may appear within 15 seconds with
further detail.
2) TO AVOID BREAKING THE GLASS DISPLAY
a. Do not apply force directly to the glass display
b. Holding the display horizontally
i. Center the display cavity on the base
ii. Press both sides equally until the snaps engage
3) AVOID EXCESSIVE FORCE TO THE CLASS DISPLAY
13.2. External Components
•
Proximity Sensor - Detects a person approaching the HD Display. If the HD
Display is in Screen Saver mode and the Proximity Detect feature is set to
ON, the proximity sensor takes the HD Display out of screen saver mode and
returns the home screen when someone approaches.
• Power Button - Resets the HD Display when pressed and held for about 5
seconds.
• microSD Card slot - Not functional, for future use
• Micro USB connector - Not functional, for future use
Proximity Sensor
Power Button
microSD Slot
Micro USB Connector
Figure 4. HD Display Components
14. Connecting Low Voltage Wiring
The following diagrams in this section illustrates the basic Lennox control wiring
for all compatible components.
14.1. Control Wiring Requirements
The following is the wiring specification requirements for installation of this
system.
• iComfort wiring size is 18 #AWG.
• Thermostat does not required shielded cable wiring.
•
Maximum total length of all connections combined is 1500 feet (457 meters).
•
Maximum length between components is 300 feet (90 meters).