23
NOTE:
For iCON Version 1.5, coolers are not supported.
g.
The Equipment Discover Detected in progress displays when equipment is
found.
h.
If the search is stopped, a Process Stopped screen will display. The search
can either
start over
on the Discovering Equipment screen or
restart
from
the point where the search was stopped from this screen.
i.
If equipment is not found, a
No Equipment Detected
screen displays. Click
on
retry
to try again.
j.
When the equipment is confirmed found, the
Equipment Discovered
screen displays the number of units and types found. From this screen, the
options are
RESTART SEARCH
or
NEXT.
Select
NEXT
if all HVAC systems
and building automation controllers have been discovered.
Figure 12. Equipment Discovered Indicators
k.
The next screen indicates “Tap on each category to rename to equipment:”
Options are
SKIP
or
START
. Select
START
.
l.
On the
Configure HVAC Equipment
screen you can edit the (HVAC) zone
name by selecting
zone name
. A pop-up screen will appear where you can
enter the desired (HVAC)
zone name
. Select
OK
to continue
NOTE:
You can enter up to 20 characters. However, only nine characters can
be displayed on the d
NOTE:
For iCON Version 1, zoning is not supported. All references in the user
interface are actually referring to the HVAC system itself.
m.
The next screen will display the new (HVAC) zone name just entered. The
S-Bus address for the unit controller or NTC is also listed. To procedure
select
NEXT
.
NOTE:
The building automation controllers cannot be renamed.
CONFIGURING HVAC EQUIPMENT
C16
CONFIGURE HVAC EQUIPMENT
ZONE NAME
ZONE 1.1
NEXT
S-BUS ADDRESS: 001
BACK
ZONES: 5
CONFIGURED: 1
COOLERS: 3
CONFIGURED: 0
INPUTS / OUTPUTS: 24
CONFIGURED: 0
Figure 13. Renaming Zone
15.3. Building Controller Inputs and Outputs Setup
a.
The next screen is Configure Building Automation Equipment.
b.
During the next set of screens you will need to assign an digital and analog
output names and assigned a category for each. For example, output name
is called main lights and the category will be
lights
. Also listed is the building
controller M-Bus address. The following are the outputs/inputs available on
iCON Building Controller:
• Eight Digital Outputs
• Two Analog Outputs
• Four Digital Inputs
• Four Analog Inputs
• One Analog Input for a Pressure Transducer which can be set for either
300 or 500 PSIG.
• One Light Sensor Input
For specifications and connection requirements on all inputs and outputs,
please refer to the building controller installation instruction.
NOTE:
In order the create schedules, schedules with dependencies, alerts
and conditions, all inputs and outputs that are going to be used must
be named and assigned to a category.
c.
Once all outputs and inputs have been named and assigned a category, the
