I
Stove Damper Controls
Traditions P11
The damper rod is located under the bottom plate, on the
right hand side of the stove, just behind the ash pan (see Fig.
A). It is very important to setup your damper prior to burning
your Traditions pellet stove, as it is likely to shift during ship
ment.
The damper plate on the Traditions contains nine notches
spaced in 1/4" increments that aid in positioning (see Fig. C).
0
For initial setup, push the damper all the way in (when facing
the front of the stove, in is to the left, and out is to the right) and
slowly pull back three notches (see Fig. D).
.
o
This setting should provide an adequate air to fuel ratio for
most installations.
Profile 20 and Profile 30 Freestanding and Profile 30 In
sert
The damper rod is located behind the right-hand side panel
of the Profile-20 freestanding and behind the left-hand side
panel of the Profile-30 freestanding and on the left surround
panel of the Profile-30 Insert. It is very important to setup
your damper prior to burning your Profile series pellet stove,
as it is likely to shift during shipment.
The damper plate on the Profile contains nine notches
spaced in 1/8" increments that aid in positioning (see figures
E&F).
r.l
.__
____
....,.r
___
....a,;--,,,,..., _,___
____
--J
_________
___,
\
�
;
-
--
,
_
_
J
Fig. E
CLOSED
For initial setup, push the damper all the way in (when facing
the front of the stove, in is to the center of the stove, and out
is away from the center of the stove) and slowly pull back
three to four notches (see figure E). This setting should pro
vide an adequate air to fuel ratio for most installations .
0
0
0
Fig. F
OPEN 4 NOTCHES
Page 10