rack in which you are installing the DIMM for at least 2 seconds; then, remove the DIMM from its
package.
Step 6. To install the DIMMs, repeat the following steps for each DIMM that you install.
a. Make sure that both retaining clips on the DIMM connector into which you are installing the
DIMM are in the open position (standing straight up).
b. Turn the DIMM so that the DIMM keys align correctly with the DIMM connector on the system
board.
Attention:
To avoid breaking the retaining clips or damaging the DIMM connector, handle the
clips gently.
c. Press the DIMM into the DIMM connector. The retaining clips lock the DIMM into the
connector.
d. Make sure that the small tabs on the retaining clips are in the notches on the DIMM. If there is a
gap between the DIMM and the retaining clips, the DIMM has not been correctly installed.
Press the DIMM firmly into the connector, and then press the retaining clips toward the DIMM
until the tabs are fully seated. When the DIMM is correctly installed, the retaining clips are
parallel to the sides of the DIMM.
Removing a DIMM - IBM MAX5
Use this information to remove a dual inline memory module (DIMM) from the IBM MAX5 expansion blade.
The following illustration shows how to remove a DIMM from the expansion blade.
36
BladeCenter HX5 Blade ServerInstallation and User's Guide
Summary of Contents for 1909
