Hardware Maintenance Manual
54
Replacing the remote control
Note:
Remove the batteries from a non-working remote control before you
return it to Lenovo for a replacement.
Completing the installation
After replacing the parts, you need to close the computer cover and
reconnect the cables, including telephone lines and power cables. Also,
depending on the part that was replaced, you might need to confirm the
updated information in the Setup Utility program. Refer to “Starting the
Setup Utility” in the
User Guide
or in the
Hardware Maintenance Manual
.
To complete a parts installation (completing the parts
installation of your actual computer should be taken as
the final step):
1. Ensure that all components have been reassembled correctly and that
no tools or loose screws are left inside your computer. Refer to “Locating
components and ports/sockets” for the location of the various
components.
2. Make sure that the cables are connected correctly before installing the
computer cover.
Important
Correctly route all power supply cables to avoid interference with the
drive bay assembly. Keep cables clear of the hinges and sides of the
computer chassis.
3. Position the computer cover on the chassis so that the tabs on the
cover align with the slots of the chassis.
