15. Reinstall the hard disk drive. See “Replacing the hard disk drive” on page 114.
16. Reconnect the heat sink and fan assembly cable to the microprocessor fan connector on the system
board.
17. Go to “Completing the parts replacement” on page 123.
Replacing the system board
Attention
Do not open your computer or attempt any repair before reading and understanding the “Important safety
information” in the
ThinkCentre Safety and Warranty Guide
that came with your computer. To obtain a copy
of the
ThinkCentre Safety and Warranty Guide
, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the system board.
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and wait
three to five minutes to let the computer cool before opening the computer cover.
To replace the system board:
1. Open the computer cover. See “Opening the computer cover” on page 98.
2. Pivot the drive bay assembly upward to gain access to the system board.
3. Remove the hard disk drive. See “Replacing the hard disk drive” on page 114.
4. Remove all memory modules and PCI cards that are currently installed. See “Replacing a memory
module” on page 103 and “Replacing a PCI card” on page 104.
5. Carefully take note of the location of all cable connections on the system board and disconnect all the
cables. See “Locating parts on the system board” on page 100.
6. Remove the heat sink and fan assembly from the failing system board. See “Replacing the heat sink” on
page 108.
7. Carefully slide the system board so that it can be released from the four mounting studs that secure the
system board in place.
8. Lift the system board out of the chassis.
9. Remove the microprocessor from the failing system board and install it on the new system board. See
“Replacing the microprocessor” on page 109.
10. Install the new system board into the chassis by aligning the four mounting studs in the chassis with
the corresponding holes on the new system board, and then carefully slide the new system board in to
the chassis until it is secured in place by the four mounting studs.
11. Install all memory modules and adapter cards removed from the failing system board on the new system
board.
12. Install the heat sink and fan assembly and connect the heat sink and fan assembly cable to the new
system board. See “Replacing the heat sink” on page 108.
13. Reinstall the hard disk drive. See “Replacing the hard disk drive” on page 114.
14. Reconnect all remaining cables to the system board. See “Locating parts on the system board” on
page 100.
15. Go to “Completing the parts replacement” on page 94.
112
ThinkCentre Hardware Maintenance Manual
Summary of Contents for 3699
