Lenovo 5468 Setup Manual Download

Page: 34 / 90

Installation Guidelines

Use the installation guidelines to install components in your solution.

Before installing optional devices, read the following notices carefully:

Attention:

Prevent exposure to static electricity, which might lead to system halt and loss of data, by

keeping static-sensitive components in their static-protective packages until installation, and handling these
devices with an electrostatic-discharge wrist strap or other grounding system.

• Read the safety information and guidelines to ensure that you work safely.

– A complete list of safety information for all products is available at:

http://thinksystem.lenovofiles.com/help/topic/safety_documentation/pdf_files.html

– The following guidelines are available as well: “Handling static-sensitive devices” on page 32 and

“Working inside the solution with the power on” on page 31.

• Make sure the components you are installing are supported by the solution. For a list of supported

optional components for the solution, see

http://www.lenovo.com/us/en/serverproven/

• When you install a new solution, download and apply the latest firmware. This will help ensure that any

known issues are addressed, and that your solution is ready to work with optimal performance. Go to

ThinkSystem SD650 Dual Node DWC Tray and NeXtScale n1200 DWC Enclosure Drivers and Software

download firmware updates for your solution.

Important:

Some cluster solutions require specific code levels or coordinated code updates. If the

component is part of a cluster solution, verify that the latest level of code is supported for the cluster
solution before you update the code.

• It is good practice to make sure that the solution is working correctly before you install an optional

component.

• Keep the working area clean, and place removed components on a flat and smooth surface that does not

shake or tilt.

• Do not attempt to lift an object that might be too heavy for you. If you have to lift a heavy object, read the

following precautions carefully:

– Make sure that you can stand steadily without slipping.

– Distribute the weight of the object equally between your feet.

– Use a slow lifting force. Never move suddenly or twist when you lift a heavy object.

– To avoid straining the muscles in your back, lift by standing or by pushing up with your leg muscles.

– Ensure to remove all trays from the enclosure before lifting the enclosure.

• Make sure that you have an adequate number of properly grounded electrical outlets for the solution,

monitor, and other devices.

• Back up all important data before you make changes related to the disk drives.

• Have a small flat-blade screwdriver, a small Phillips screwdriver, and a T8 torx screwdriver available.

• To view the error LEDs on the system board and internal components, press Light Path Diagnostics

button on system board.

• You do not have to turn off the solution to remove or install hot-swap power supplies. However, you must

turn off the solution before you perform any steps that involve removing or installing adapter cables, and
you must disconnect the power source from the solution before you perform any steps that involve
removing or installing a riser card.

• Blue on a component indicates touch points, where you can grip to remove a component from or install it

in the solution, open or close a latch, and so on.

ThinkSystem SD650 Dual Node DWC Tray and NeXtScale n1200 DWC Enclosure Setup Guide