To replace the camera:
Step 1.
Remove any media (disks, CDs, DVDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2.
Unplug all power cords from electrical outlets.
Step 3.
Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to “Left and right view”
and “Rear view” for help with locating the various connectors.
Step 4.
Remove the stand base. Refer to “Removing the stand base”.
Step 5.
Remove the foot cover. Refer to “Removing the foot cover”.
Step 6.
Remove the optical drive. Refer to “Replacing the optical drive”.
Step 7.
Remove the stand holder. Refer to “Removing the stand holder”.
Step 8.
Remove the middle cover. Refer to “Removing the middle cover”.
Step 9.
Remove the rear deco. Refer to “Replacing the rear deco”.
Step 10. Removing the camera protecting rubber as shown..
1
Chapter 7
.
Replacing hardware
45
Summary of Contents for C40 Series
