9. Use the network settings provided by your network administrator in the
Configure Network
Settings
wizard to configure controller B’s network settings, and then select
Finish
.
10. Connect controller B to your network.
11. Validate controller B’s network settings by entering controller B’s newly configured IP address
in a browser.
If you lose the connection to controller B, you can use your previously
validated connection to controller A to reestablish connection to controller B
through controller A.
4.4.3. After installing the hardware
After you have installed your hardware, use the ThinkSystem System Manager to configure and
manage your storage system.
Before you begin
• You have configured your management ports and have verified and recorded your password
and IP addresses.
Steps
1. Use the ThinkSystem System Manager to configure and manage your storage arrays.
2. In the simplest network configuration, connect your controller to a web browser and use
ThinkSystem System Manager for managing a single DE2000H, DE4000H, or DE6000H series
storage array.
For accessing System Manager, use the same IP
addresses that you used to configure your
management ports.
29
Summary of Contents for DE2000H
Page 35: ......
