8. Connect the signal cable and the power cable to the storage drive.
9. Reinstall all removed parts. Then, reconnect the power cord and all disconnected cables to the
computer.
Storage drive bay
Prerequisite
Before you start, read Appendix A “Important safety information” on page 61 and print the following
instructions.
Replacement procedure
1. Remove the power cord. See “Power cord” on page 26.
2. Remove the computer cover. See “Computer cover” on page 27.
3. Remove the front bezel. See “Front bezel” on page 29.
4. Disconnect the signal cable and the power cable from the storage drive.
Notes:
The storage drive will vary depending on your model:
• If your model has a 3.5-inch storage drive, follow step
1
on the illustration.
• If your model has a 2.5-inch storage drive, follow step
2
on the illustration.
34
User Guide
Summary of Contents for IdeaCentre C5 14IMB05
