12. Connect the signal cable and the power cable to the storage drive.
Notes:
The storage drive will vary depending on your model:
• If your model has a 3.5-inch storage drive, follow step
5
on the illustration.
• If your model has a 2.5-inch storage drive, follow step
6
on the illustration.
13. Reinstall all removed parts. Then, reconnect the power cord and all disconnected cables to the
computer.
3.5-inch storage drive
Prerequisite
Before you start, read Appendix A “Important safety information” on page 61 and print the following
instructions.
Attention:
The internal storage drive is sensitive. Inappropriate handling might cause damage and
permanent loss of data. When handling the internal storage drive, observe the following guidelines:
• Replace the internal storage drive only for upgrade or repair. The internal storage drive is not designed for
frequent changes or replacement.
• Before replacing the internal storage drive, make a backup copy of all the data that you want to keep.
• Do not touch the contact edge of the internal storage drive. Otherwise, the internal storage drive might get
damaged.
40
User Guide
Summary of Contents for IdeaCentre C5 14IMB05
