PCI-Express card holder
Prerequisite
Before you start, read Appendix A “Important safety information” on page 61 and print the following
instructions.
Replacement procedure
1. Remove the power cord. See “Power cord” on page 26.
2. Remove the computer cover. See “Computer cover” on page 27.
3. Remove the storage drive bay. See Storage drive bay.
4. Press the two tabs to release the PCI-Express card holder from the storage drive bay.
5. Remove the PCI-Express card holder from the storage drive bay.
6. Install the new PCI-Express card holder onto the storage drive bay.
7. Make sure that the PCI-Express card holder tabs are fully latched into the storage drive bay.
51
Summary of Contents for IdeaCentre C5 14IMB05
