56
ideapad 300S-14ISK/ideapad 500S-14ISK Hardware
Maintenance Manual
1140 Antenna assembly and LCD cover
For access, remove these FRUs in order:
• “1010 Base cover” on page 33
• “1020 Battery pack” on page 35
• “1030 Hard disk drive” on page 37
• “1040 PCI Express Mini Card for wireless LAN” on page 39
• “1050 DIMM” on page 41
• “1060 Fan assembly and heat sink assembly” on page 42
• “1070 LCD unit” on page 43
• “1080 System board” on page 45
• “1090 Speakers” on page 48
• “1100 Power assembly, Touchpad module and IO board” on page 49
• “1110 LCD front bezel” on page 51
• “1120 LCD panel, LCD cable and hinges” on page 53
• “1130 Integrated camera” on page 55
Figure 14. Removal steps of antenna assembly and LCD cover
Note
: The integrated camera is stuck on the top center of the LCD cover.
Peel off the adhesive tapes securing the antenna boards, release the cables
from the cable guide, and then remove the antenna assembly in the direction
shown by arrows
1
.
1
1
When installing:
Route the antenna cables along the cable guides and secure
the antenna boards with adhesive tapes. As you route the cables, make sure
that they are not subjected to any tension. Tension could cause the cables to
be damaged by the cable guides, or a wire to be broken.
