56
ideapad 720S-14IKB Hardware Maintenance Manual
1140 Antenna assembly and LCD cover
For access, remove these FRUs in order:
• “1010 Base cover” on page 34
• “1020 Battery pack” on page 36
• “1030 PCI Express Mini Card for wireless LAN” on page 37
• “1040 SSD Card (On select models)” on page 39
• “1060 Fan assembly and heat sink assembly” on page 42
• “1080 System board” on page 45
• “1100 Power assembly, Finger print board and Touchpad module” on page 49
• “1110 LCD front bezel” on page 51
• “1120 LCD panel, LCD cable, LCD bracket and hinges” on page 53
• “1130 Integrated camera” on page 55
Figure 14. Removal steps of antenna assembly and LCD cover
Peel off the adhesive tapes securing the antenna boards, release the cables
from the cable guide, and then remove the antenna assembly in the direction
shown by arrows
1
.
a
a
When installing:
Route the antenna cables along the cable guides and secure
the antenna boards with adhesive tapes. As you route the cables, make sure
that they are not subjected to any tension. Tension could cause the cables to
be damaged by the cable guides, or a wire to be broken.