16
Components
S3200 CNC controller module — rear panel components
Figure 4
shows CNC ports configured with SFPs supporting either 4/8/16 Gb FC or 10GbE iSCSI. The
SFPs look identical. Refer to the CNC LEDs that apply to the specific configuration of your CNC ports.
Figure 4
S3200 CNC controller module face plate (FC or 10GbE iSCSI)
Figure 5
shows CNC ports configured with 1 Gb RJ-45 SFPs.
Figure 5
S3200 CNC controller module face plate (1 Gb RJ-45)
NOTE:
See
CNC ports used for host connection
on page 10 for more information about CNC technology. For
CNC port configuration, see the “Configuring host ports” topic within the Storage Manager Guide or online
help.
1
CNC ports used for host connection
(see
Install an SFP transceiver
on page 80)
2
CLI port (USB - Type B) [see Appendix D]
3
Service port 2 (used by service personnel only)
4
Reserved for future use
5
Network port
6
Service port 1 (used by service personnel only)
7
Disabled button (used by engineering only)
(Sticker shown covering the opening)
8
mini-SAS expansion port
1
CNC ports used for host connection
(see
Install an SFP transceiver
on page 80)
2
CLI port (USB - Type B) [see Appendix D]
3
Service port 2 (used by service personnel only)
4
Reserved for future use
5
Network port
6
Service port 1 (used by service personnel only)
7
Disabled button (used by engineering only)
(Sticker shown covering the opening)
8
mini-SAS expansion port
CACHE
CLI
CLI
LINK
ACT
6Gb/s
SERVICE−1
SERVICE−2
PORT 0
PORT 1
PORT 2
PORT 3
5
2
3
6
8
1
7
4
= FC LEDs
= 10GbE iSCSI LEDs
CACHE
CLI
CLI
LINK
ACT
6Gb/s
SERVICE−1
SERVICE−2
PORT 0
PORT 1
PORT 2
PORT 3
5
2
3
6
8
1
7
4
= FC LEDs
= 1Gb iSCSI LEDs (all CNC ports use 1 Gb RJ-45 SFPs in this figure)
