Step 7.
Install the 2.5-inch hard disk drives (see “Installing a 2.5-inch hot-swap hard disk drive” on page
200).
Step 8.
Install the drive bay filler panels that come with the option into empty drive bays.
Step 9.
Connect the backplane configuration cable, power cable, signal cable, and the configuration cable
(see “Internal cable routing and connectors” on page 312).
Note:
You may need to install the two screws on the backplane configuration cable.
Backplane
configuration
cable
Screws
Signal connector
(backplane configuration)
Figure 127. Put screws on the backplane
Step 10. Install the bezel (see “Installing the bezel” on page 187).
Step 11. Install the left-side cover (see “Installing the left-side cover” on page 185).
Step 12. Reconnect the power cords and any cables that you removed.
Step 13. Slide the server into the rack.
If you have replaced a server component or installed an optional device in the server, you need to reconnect
the power cords and all external cables, and turn on the server and peripheral devices.
Removing an adapter
Use this information to remove an adapter.
Read the safety information in “Safety” on page v and “Installation guidelines” on page 35.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To remove an adapter, complete the following steps.
Step 1.
Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention:
Do not allow the server to fall over.
Step 2.
Unlock and remove the left-side cover (see “Removing the left-side cover” on page 184).
Removing and replacing components
213
Summary of Contents for System x3500 M4
