Compute block connections (single-interconnect configuration)
The compute block consists of an enclosure with up to four compute nodes, which are numbered as follows:
Connect the compute nodes according to the populated compute node location and corresponding port
mapping. The cables to be used are clearly labeled; make sure that you use the correct cables.
You need two SFP+ Direct Attach Cables (DACs) for each populated compute node.
The compute block port mapping is as follows:
Front compute node location
Back network port mapping
Network interconnect port
Top left
Compute node 3, port 1 (C.3.1)
Interconnect, port 5
Compute node 3, port 2 (C.3.2)
Interconnect, port 6
Top right
Compute node 4, port 1 (C.4.1)
Interconnect, port 7
Compute node 4, port 2 (C.4.2)
Interconnect, port 8
Bottom left
Compute node 1, port 1 (C.1.1)
Interconnect, port 1
Compute node 1, port 2 (C.1.2)
Interconnect, port 2
Bottom right
Compute node 2, port 1 (C.2.1)
Interconnect, port 3
Compute node 2, port 2 (C.2.2)
Interconnect, port 4
Note:
You only need to cable the number of compute nodes that are installed in the compute enclosure.
.
Part replacement and maintenance procedures
135
Summary of Contents for ThinkAgile CP
