Installing the driver for Intel Management Engine Interface
To install the driver for Intel Management Engine Interface, do the following:
1. Copy the driver for Intel Management Engine Interface from the
ThinkServer EasyStartup DVD
that
comes with your server to a USB storage device. Connect the USB storage device to your server.
2. Use the following commands to install the driver:
e:
cd Management
Pnputil –i –a *.inf
Note:
In the command lines,
e:
represents the drive letter of your USB storage device and
Management
represents the name of the folder where the driver is stored.
3. Restart your server after the installation is completed.
Installing the driver for an HBA card
To install the driver for an HBA card, do the following:
1. Copy the driver for an HBA card from the
ThinkServer EasyStartup DVD
that comes with your server to a
USB storage device. Connect the USB storage device to your server.
2. Use the following commands to install the driver:
e:
cd HBA
Pnputil –i –a *.inf
Note:
In the command lines,
e:
represents the drive letter of your USB storage device and
HBA
represents the name of the folder where the driver is stored.
3. Restart your server after the installation is completed.
Installing the driver for a CNA card
To install the driver for a CNA card, do the following:
1. Copy the driver for a CNA card from the
ThinkServer EasyStartup DVD
that comes with your server to a
USB storage device. Connect the USB storage device to your server.
2. Use the following commands to install the driver:
e:
cd CNA
Pnputil –i –a *.inf
Note:
In the command lines,
e:
represents the drive letter of your USB storage device and
CNA
represents the name of the folder where the driver is stored.
3. Restart your server after the installation is completed.
Installing the Hyper-V Server 2012 operating system
This topic provides instructions on how to install the Hyper-V Server 2012 operating system.
To install the Hyper-V Server 2012 operating system, do the following:
1. Insert the operating system installation disc into the optical drive that you have set as the first startup
device. Then, start the server from the optical drive.
2. When the message
Press any key to boot from cd or dvd...
is displayed, press any key. If the message
Windows Setup [EMS Enabled]
is displayed, press Enter. Wait several minutes for the system to load
the files.
Chapter 2
.
Installing an operating system in legacy mode
43
Summary of Contents for ThinkServer RD340
