5. Remove the TPM installed on the TPM connector by lifting it straight up.
Note:
Carefully handle the TPM by its edges.
Figure 68. Removing the TPM
6. If you have lifted up the riser card assembly 1, reinstall it into the chassis. See “Replacing the riser
7. If you are instructed to return the old TPM, follow all packaging instructions and use any packaging
materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the removal procedure, go to “Completing the parts replacement” on page 184.
Installing or replacing a hot-swap redundant power supply
Attention:
Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 75.
Installing, removing, or replacing hardware
113
Summary of Contents for ThinkServer RD640
