9. When the installation is completed, click
Next
. Then, click
Finish
.
Installing the driver for Intel Management Engine Interface
To install the driver for the Intel Management Engine Interface, do the following:
1. Download the driver for the Intel Management Engine Interface from the Lenovo Support Web site. If the
driver is a compressed file, unzip it to a folder. The most up-to-date device drivers for various server
models are always available for download on the Lenovo Support Web site at:
http://www.lenovo.com/drivers
2. Copy the folder that contains the driver to a USB storage device and connect the USB storage device to
your server.
3. Log in to the operating system.
4. In the Device Manager window, click
View
➙
Show hidden devices
.
5. Right-click
Other devices-PCI Simple Communications Controller
and choose
Update Driver
Software
.
6. In the Update Driver Software window, click
Browse my computer for driver software
.
7. Go to the folder where the driver is stored, click
OK
, and then click
Next
. The installation begins.
8. When the installation is completed, click
Close
.
Installing the driver for SATA AHCI
To install the driver for SATA AHCI, do the following:
1. Download the driver for SATA AHCI from the Lenovo Web site. If the driver is a compressed file, unzip it
to a folder. The most up-to-date device drivers for various server models are always available on the
Lenovo Web site at:
http://www.lenovo.com/drivers
2. Copy the folder that contains the driver to your USB storage device and connect the USB storage
device to your server.
3. Log in to the operating system.
4. In the Device Manager window, right-click the device which you want to install drivers for.
5. Click
Update Driver Software
➙
Browse my computer for driver software
.
6. Go to the folder where the driver is stored, click
OK
, and then click
Next
.
7. When the installation is completed, click
Close
.
Installing the Hyper-V Server 2012 R2 operating system
Note:
The driver for the HBA card or CNA card is installed during the operating system installation.
To install the Hyper-V Server 2012 R2 operating system, do the following:
1. Insert the operating system installation disc into the optical drive that you have set as the first startup
device. Then, start the server from the optical drive.
Note:
If the message
Press any key to boot from cd
is displayed, press any key. If the message
Windows
Setup [EMS Enabled]
is displayed, press Enter. Wait several minutes for the system to load the files.
2. When the “Microsoft Hyper-V Server 2012 R2” window is displayed, configure the language and other
required options, and then click
Next
.
3. Click
Install now
.
4. Read the license terms and select
I accept the license terms
. Click
Next
.
Installing an operating system in legacy mode
23
Summary of Contents for ThinkServer TD340
