3. Use the following commands to install the driver:
• For LPe1250 (single-port FC 8G), LPe12002 (dual-port FC 8G), and LPe16002B(dual-port FC 16G)
HBA cards:
cd /tmp
tar zxvf elx-lpfc-dd-rhel5-8.2.2.15-1-1.tar.gz
cd elx-lpfc-dd-rhel5-8.2.2.15-1-1
./elx_lpfc_install.sh
Notes:
– If the file extension is not .tar.gz, skip the second command.
– In the command lines,
elx-lpfc-dd-rhel6-8.3.7.18-1-1
represents the name of the folder where the
driver is stored.
elx_lpfc_install.sh
represents the driver name. Use the corresponding file name
on your server.
• For 5QLE2562 (dual-port FC 8G) and 7QLE2562 (dual-port FC 8G) HBA cards:
cd /tmp
cd / qla2xxx-8.04.00.15.5.6-k
./extras/build.sh
Note:
In the command lines,
qla2xxx-8.04.00.15.5.6-k
represents the name of the folder where
the driver is stored;
extras
represents the name of the folder in the driver package; and
build.sh
represents the driver name. Use the corresponding file name on your server.
4. Restart your server and the installation is completed.
Installing the driver for a CNA card
To install the driver for a CNA card, do the following:
1. Copy the driver for a CNA card from the
ThinkServer EasyStartup
DVD to your local drive. Double-click
the EXE file to unzip it to a folder. Copy the folder to a USB storage device and connect the USB
storage device to your server.
2. Log in to the operating system and copy the folder from the USB storage device to the
/tmp
directory
on your server.
3. Use the following commands to install the driver:
• For Fibre Channel over Ethernet (FCoE) and iSCSI over Ethernet (ISOE) protocols:
cd /tmp
cd qla2xxx-8.04.00.15.5.6-k
./extras/build.sh
Note:
In the command lines,
qla2xxx-8.04.00.15.5.6-k
represents the name of the folder where
the driver is stored;
extras
represents the name of the folder in the driver package; and
build.sh
represents the driver name. Use the corresponding file name on your server.
• For NIC protocol:
cd /tmp
cd qlcnic-5.2.29.45_130308_rhel5.9_2.6.18-348.el5
./qicnic-src-install.sh -b
./qlcnic-src-install.sh -i
Note:
In the command lines,
qlcnic-5.2.29.45_130308_rhel5.9_2.6.18-348.el5
represents the name
of the folder where the driver is stored.
qlcnic-src-install.sh
represents the driver name. Use the
corresponding file name on your server.
4. Restart your server and the installation is completed.
30
ThinkServer TD340 Operating System Installation Guide
Summary of Contents for ThinkServer TD340
