7. Position the new memory module over the memory slot. Ensure that the notch
1
on the memory
module aligns correctly with the slot key
2
on the system board. Push the memory module straight
down into the slot until the retaining clips close.
Figure 19. Installing a memory module
8. Reinstall the PCI Express x16 graphics card if you have removed it.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 142.
Installing or replacing a device in the optical drive bay
Important:
Before you replace any FRU, be sure to read and understand Chapter 1 “Safety information”
on page 1.
The optical drive bays support the following two devices. Depending on your computer model, one or
both of them might be installed:
• Optical drive
• 5.25-inch flex module equipped with some or all of the following components:
– Slim optical drive
– Card reader
– eSATA connector
– IEEE 1394 connector
For detailed information about the installation and replacement of devices in the 5.25-inch flex module, see
“Installing or replacing a device in the 5.25-inch flex module” on page 93.
This section provides instructions on how to install or replace an optical drive.
Note:
The following instructions also apply to a flex module.
To install or replace an optical drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 83.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 84.
90
ThinkStation P300 Hardware Maintenance Manual
Summary of Contents for ThinkStation P300
