80
3.8 Save & Exit
Use the arrow keys to select Save & Exit on top of the screen. The Save and Exit screen looks like below.
3.8.1 Save Options
Save Changes and Exit:
Set this option to exit system setup after saving the changes.
Discard Changes and Exit:
Select this option to quit the BIOS Setup without making any permanent changes to the system
configuration.
Save Changes and Reset:
Select this option to reset the system after saving the changes
Save Changes:
Select this option to save the changes from users and allow users to continue to make changes.
Discard Changes:
Select this option to revert the changes from users.
Discard Changes and Reset:
Select this option to reset the system without making any permanent changes to the system
configuration.
NOTE: The BIOS is reset when you select “Save Changes and Exit” option when users changes below BIOS setting:
L3 Cache Enable
Memory Operating Speed Selection.
3.8.2 Default Options
Restore Defaults:
Select this option to restore the factory settings which is designed for maximum system stability, but not for
maximum performance.
Save as User Defaults:
Select this option to enable the user to save any changes to the BIOS setup for future use.
Restore User Defaults:
Select this option to retrieve user-defined settings that were saved previously.
Summary of Contents for ThinkSystem HR350A
