Chapter 2.
2-3
Adjusting your monitor image
This section describes the control features to adjust
your monitor image.
Using the direct access controls
The direct access controls can be used when the On Screen Display (OSD) is not
displayed.
Table 2-1.
Direct access controls
Icon
Control
Description
1
Input Source
Switches the video input source
DDC-CI
Press and hold for 10 seconds to enable or disable
the DDC-CI function
Increase/Up
Up browsing key
For increasing the value on adjustment bar/tune in
Press to move to last item
2
Brightness
Direct access to Brightness adjustment
Low Blue Light
Press and hold for 3 seconds to enable Low Blue
Light or disable Low Blue Light
Decrease/Down
Down browsing key
For decreasing the value on adjustment bar/tune in
Press to move to next item
3
Menu
To access OSD menu
Press to confirm selection
Press and hold for 10 seconds will lock menu/un-
lock menu
Enter
Press to enter next level on main menu/sub menu
status or enter previous level on adjustment bar
4
Volume
Up/Down
Press to control Speaker Volume up/down