Figure 37. Installing the coin-cell battery
6. Reinstall the removed parts. To complete the replacement, see “Completing the parts replacement” on
To dispose of the coin-cell battery, refer to
Lithium coin-cell battery notice
in theSafety and Warranty Guide.
Replacing the memory module
Attention:
Do not open your computer or attempt any repairs before reading the
Important Product
Information Guide
.
If your computer supports one memory module, install the module into the DIMM 1 slot. If your computer
supports two memory modules, install one memory module into the DIMM 1 slot first and then install the
other into the DIMM 2 slot.
1. Remove any media from the drives and turn off all connected devices and the computer. Disconnect all
power cords from electrical outlets and disconnect all cables from the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 15.
3. Remove the front bezel. See “Replacing the front bezel” on page 16.
4. Pivot the drive bay assembly upward. See “Pivoting the drive bay assembly upward and downward” on
5. Replace the memory module.
.
33
Summary of Contents for V330-15IGM
