Replacing FRUs
51
Replacing the microprocessor
Attention
Do not open your computer or attempt any repairs before reading the
Important
Product Information Guide
.
Caution
The heat sink and microprocessor might be very hot. Before you open the
computer cover, turn off the computer and wait several minutes until the
computer is cool.
1
Remove the computer cover. For details, see
2
Remove the front bezel. For details, see
3
Pivot the drive bay assembly upward. For details, see
Pivoting the drive bay assembly upward and
4
Remove the heat sink and fan assembly. For details, see
Replacing the heat sink and fan assembly.
5
Record the cable routing and cable connections, and then disconnect all cables from the system
board. See
6
Replace the microprocessor.
Note
• Your microprocessor and socket might look different from the one illustrated.
• Touch only the edges of the microprocessor. Do not touch the gold contacts on
the bottom.
•
Do not drop anything onto the microprocessor socket while it is exposed. The
socket pins must be kept as clean as possible.
1
2