00000
00000
00000
00000
00000
00000
00000
00000
00000
00000
000
000
000
0000
0000
0000
0000
000
000
000
000
000
000
0000
0000
0000
000
000
000
0000
0000
0000
8. Rotate the drive tray handle to the closed position.
9. Check the hard disk drive status indicator to make sure that the hard disk drive is operating
correctly.After you replace a failed hard disk drive, the green activity LED flashes as the disk spins up.
The yellow LED turns off after approximately 1 minute. If the new drive starts to rebuild, the yellow LED
flashes slowly, and the green activity LED remains lit during the rebuild process. If the yellow LED
remains lit, seeChapter 4 “Troubleshooting” on page 115 for more information.
Note:
You might have to re-configure the disk arrays after you install hard disk drives. See the RAID
documentation on the Lenovo website at http://www.lenovo.com/support for information about RAID
adapters.
10. Close the bezel.
11. Lock the left-side cover.
If you have other devices to install or remove, do so now. Otherwise, go to “Completing the installation”
on page 83.
Removing a 3.5-inch simple-swap hard disk drive
Use this information to remove a 3.5-inch simple-swap hard disk drive.
Before removing a 3.5-inch simple-swap hard disk drive, read the following information:
• Inspect the drive tray for signs of damage.
• To maintain proper system cooling, do not operate the server for more than 10 minutes without either a
drive or a filler panel installed in each drive bay.
• You have to turn off the server to install simple-swap drives in the simple-swap drive bays.
To remove a 3.5-inch simple-swap hard disk drive, complete the following steps.
1. Read the safety information that begins “Safety” on page v and “Installation guidelines” on page 163.
Attention:
Static electricity that is released to internal server components when the server is
powered-on might cause the server to halt, which might result in the loss of data. To avoid this potential
Removing and replacing components
201
Summary of Contents for x3300 M4 7382
