Table 7. Components associated with power rail errors (continued)
Pwr rail error in the IMM event log
Components
Pwr rail I error
• Hard disk drives at backplane assembly 1 and/or
backplane assembly 2
• Hard disk drive backplane assembly 1 and/or backplane
assembly 2
Pwr rail J error
• Fans 1 through 6
Pwr rail K error
• Optional adapter (if one is present) installed in riser-card
assembly 1 (or Rear Hard disk Drives in Rear two
Hard-disk-drive kit on Riser 1)
• Riser-card assembly 1 (or Rear two Hard-disk-drive kit
on Riser 1)
• Optional adapter (if one is present) installed in PCIe slot
4
• Optional adapter (if one is present) installed in PCIe slot
5
• Raid Card in Raid slot
Pwr rail L error
• Optional PCI adaptor power cable-correlated PCI
adaptor
• PCI Riser Card Assembly where the optional PCI
adaptor power cable-correlated PCI adaptor is installed
• Optional PCI adaptor power cable (if one is present)
Pwr rail M error
• Optional PCI adaptor power cable-correlated PCI
adaptor
• PCI Riser Card Assembly where the optional PCI
adaptor power cable-correlated PCI adaptor is installed
• Optional PCI adaptor power cable (if one is present)
d.
Replace the identified component.
Step 5.
Remove the adapters and disconnect the cables and power cords to all internal and external
devices until the server is at the minimum configuration that is required for the server to start (see
“Power-supply LEDs” on page 75 for the minimum configuration).
Step 6.
Reconnect all ac power cords and turn on the server. If the server starts successfully, reseat the
adapters and devices one at a time until the problem is isolated.
If the server does not start from the minimum configuration, see “Power-supply LEDs” on page 75 to replace
the components in the minimum configuration one at a time until the problem is isolated.
Solving Ethernet controller problems
The method that you use to test the Ethernet controller depends on which operating system you are using.
See the operating-system documentation for information about Ethernet controllers, and see the Ethernet
controller device-driver readme file.
Try the following procedures:
Step 1.
Make sure that the correct device drivers, which come with the server are installed and that they
are at the latest level.
Step 2.
Make sure that the Ethernet cable is installed correctly.
105
Summary of Contents for x3650 M5
