Signal cables
Power connector 3
Power connector 1
Power connector 2
Figure 297. Cable routing
Notes:
1. For the power cable connection, the NVMe backplane can only connect to the power
connector 3.
2. There might be 3 or 4 power connectors on the system board depending on your
configuration. However, this difference will not affect the cable routing. Follow the following
illustrations to complete your cable routing.
Step 14. If you removed the fan cage, install it back to the server. (See “Replacing the fan cage assembly”
Step 15. Insert the hard disk drives and the fillers the rest of the way into the bays. (See “Replacing a
hot-swap hard disk drive” on page 159).
Installing a PCIe thermal solution kit
Use this information to install a PCIe thermal solution kit.
Note:
If you are installing the Dual Port 10GB-T Ethernet Daughter Card (Option number is 00D1994) in
the server, you have to purchase and install a Lenovo System x3650 M5 PCIe thermal solution kit. See
http://www.lenovo.com/ serverproven/ for a list of supported optional devices. To order a PCIe thermal
solution kit, contact your sales representative or reseller.
The PCIe thermal solution kit contains one air baffle.
Installing, removing, and replacing components
325
Summary of Contents for x3650 M5
