-16-
Rear View
Lenox LX: Drain
Basement Connection
(NOT recommended
on floor drain)
Power Drain
(See detailed power drain pump)
Wall Drain
Hot & Cold Water Inlet: 1/2”
Drain Outlet: 1 1/2” PVC Pipe
Drain
Cold
Hot
Drain outlet MUST be 1/2”
or 3/4” for efficient drainage.
Check Valve Required
PLUMBER MUST BE UTILIZED TO INSTALL
CHECK VALVE
Pipeless Motor
Power Plug
(Small Rubber Coupling)
3/4” Elbow
3/4 PVC Pipe
3/4” PVC Pipe
Hanning DPO 40-020
Air Check Valve
Elbow
Rubber Gasket
Clear Tubing 3/4 OD 1/2”ID
Large Rubber Coupling
Poly Insert 90Elb 1/2”
Tee 3/4 x 3/4 x 1/2
3/4” PVC Pipe
(Large Rubber Coupling)
3/4 Slip x 1/2” Male Adapter
Light
Transformer
Part T
ime
Part T
ime
Full Time
3/8” Clear tube from on/off for D/P
pump insert into 2 Min. Timer.
Make sure to push in tightly.
2 Min. Timer
(D.pump)
Installation Instruction:
1. Make a hole ( size 1-3/8”) for the On/Off switch as shown (see fig 1). Pre-dril
required.
2. Placed a 1/8” clear hose into the rear of the switch and on/off switch into the
hole.
3. The discharge pump kit is made to fit onto the pedicure unit. (See fig 2)
4. Connect E-Z connector onto the drain elbow.
5. Plug discharge pump outlet into the two minute timer outlet
6. Plug two minute timer into the wall outlet.
7. It is very important that tip of the clear tub remain above the water Level with
one loop as shown.
Operation Instruction:
Warning ! DO NOT RUN DRY
1. Turn to open drain plug. 3 to 5 second for air to release from the pipe
2. Press On/Off switch to activate timer.
3. At any time, water drain completely from the basin. Press
On/Off switch to stop or built in two minute timer.
Lenox LX: Discharge Pump
(Optional)
Up to 4ft @ +/- 39 sec. with 1/2” Connection to main drain
Power Plug
Fastener
On/Off
Switch
1-3/8” Hole
for On/Off Switch
Figure 1
Figure 2
OPTIONAL
DISCHARGE PUMP
Power Plug to
Wall Outlet
DRAIN INSTRUCTION
Air breather(check Valve)Must be
above the water level.
