Lenox MS, Owner'S Manual

1. Read and follow all instructions before using the equipment.
2. Keep the cord out of heavy traffic area. To avoid fire hazard NEVER put the cord under the rugs, near heat 
generating 
    devices.
3. Always turn off the equipment before servicing.
4. Do not drop or insert any object into any openings.
5. Do not operate any equipment with a damage parts.
6. Any other use not recommended by the manufacturer may electrical shock or injury to persons.
7. Never use outdoors

When using electrical equipment, basic safety precautions should always be followed to reduce the
 risk of fire, electrical shock, and injury to persons, including the following:  

Safety Instructions

Cleaning Instruction

1. Turn the unit off and wait until the motor is fully stops.
2. Remove the front jet cover and notice the locking screw in the center
3. Remove the locking center screw (turn counter clockwise) and pull out impeller from housing.
4. Use Anti-Bacterial solution (EPA Registered) to clean all part/s.
5. After sanitization, place impeller onto the motor shaft and fasten with center locking screw ( Turn clockwise)

DURA-JET III Specifications

Model: DURA_JETIII - 

Pump: Dual Air Jet Flow

Mounting: Single 3.5” hole Diameter
                   Auto tighten Mounting screws(4)  

J&

A U

SA

120Vac, 0.4 Amp. 60Hz, 

1. Dual powerful massage jet-streams
2. Jet assembly can be attached from the pump for 
    quick cleaning and sanitizing.
3. Built-in electronic sensor for pump control.
4. AC motor (long life)
5. Extremely low power consumption .
6. Manufactured in USA.

DuraJet III Feature

Dura-Jet III

Dura Jet III 
Impeller Center
locking mechanism

Dura Jet III
Impeller