2
The illustrations used in this manual are to illustrate the operation method and product structure of the
product. Where there is a small difference between the physical item and the illustrations, please take the
physical as the standard.
IMPORTANT SAFETY INSTRUCTIONS:
CAUTION
:
To reduce the risk of fire or electric shock, do not expose this equipment, the cord or plug to rain or
moisture; do not use it anywhere near water or where water splashes or drips; do not touch the plug with
wet hands.
In the event of water or other liquids entering the device, unplug it immediately and clean and dry it as best
as possible. Then have it checked for damage by a qualified technician or contact the after-sales support
line.
Electrical safety and cord handling:
• To prevent contact with high voltage components inside, do not attempt to open the equipment.
• Before installing this equipment, make sure your outlet voltage corresponds to the voltage stated on the
appliance rating label.
• When connecting the equipment, align the plug properly and insert it fully to prevent electric shock.
• Only use this equipment with the cord and plug supplied, and do not overload the power outlet.
• If the power cord is damaged, do not use the equipment. The cord must be replaced by the manufacturer
or similarly qualified personnel to avoid a hazard. Contact the after-sales support line for advice.
• Do not repair the unit yourself. This product has no user-serviceable parts. Only have it serviced by
qualified personnel. Contact the after-sales support line for advice.
• Unplug the unit from the power outlet after use to avoid possible damage during electrical storms, or
when the equipment will be unattended or unused for an extended period.
• Do not let the cord hang over the edge of a table or counter or touch any hot surface. Do not allow
anything to rest on or roll over the power cord and run any cords so that no one steps on or trips over
them.
• Do not run the cord near heat-producing appliances such as radiators, stoves or irons. Excessive heat
could melt insulation and expose live wires.
• Always grasp the plug, not the cord, when disconnecting the unit. Pulling the cord can damage the
internal wires and may cause a fire.
Installation:
When installing the unit, make sure to place it:
• Away from heat sources, radiators or other products that produce heat.
• Away from areas with hot temperatures, high humidity or direct sunlight.
